2 in 1 Smoke and Carbon Monoxide Alarm, Twin Sensor Smoke CO Alarm (JKD-512COM) Complies with UL 217 & UL 2034 Requirements

Value: $34.99
(as of Sep 21,2022 20:03:06 UTC – Particulars)

Word: Please don’t set up it within the kitchen
Detection gasoline: smoke + carbon monoxide
Energy provide: 3 * 1.5VAA battery
Energy consumption: ≤3W
Working temperature: 0 ℃ -55 ℃ (32 ℉ -131 ℉)
Working humidity: ≤95% RH
Alarm focus:
2500PPM (± 1500PPM)
200PPM (± 50PPM)
Alarm sound stress: 70dB
Alarm mode: sound and lightweight alarm
Sensor: electrochemical sensor + infrared sensor
Look measurement: φ104mm * 104mm * 39mm (φ4in * 4in * 1.5in)
Product set up:
1. This product shouldn’t be put in within the following locations:
A). Locations the place smoke stays below regular situations
B). Places with relative humidity larger than 95%
C). Locations with massive mud, water mist and oil mist air pollution
D). Locations with excessive wind velocity (larger than 5 m / s)
2. Put the battery into the battery compartment accurately in accordance with the marked constructive and unfavorable polarities.
3. Select an acceptable location, typically put in on the ceiling within the heart of the detection house, and use the set up screws to repair the detector base to the chosen set up location.

Correct and Sturdy: The electrochemical carbon monoxide sensor is secure and dependable with low present consumption and small sensitivity drift. Photoelectric smoke sensor, minimizing false alarms. Dependable stability with SMT manufacture expertise.
Set up the facility provide for the primary time: set up AA 3 1.5V batteries, the buzzer will beep, the alarm will begin to heat up, and the show will present a countdown of two minutes. Then enter the standby state, there will likely be no show on the display screen. Beneath regular standby mode, the inexperienced gentle flashes as soon as each 30 seconds.(You possibly can put the product in a bag and blow smoke into the bag for testing).
Battery Powered & Simple to Set up: 3 AA Batterieswith low battery alert reminds you to alter the battery in time.No wire required, repair the bottom to the wall with screws.
Peak File and Hush Mode: Press “TEST” button, the show reveals the height stage detected by the alarm focus because the final reset. Lengthy press “TEST” button over 10 seconds once more for clear up. Silence the alarm instantly by urgent the “TEST” button when non-emergency trigger nuisance alarms.
Actual-time LED Show: Signifies the real-time CO and smoke focus within the surrounding. If the alarm detect CO gasoline focus over 300 PPM, the crimson gentle flashes and the buzzer make sound each 5 seconds. When detect smoke focus over than 0.1 db/m, it’s going to alarming, the blue gentle flashes, the buzzer proceed alarm at a loud 85 db sound.